Wallace Perimeter Security ALPHA, Руководство по установке и обслуживанию

Страница: 63 / 182

Alpha/Delta (Kinetic Operator) Installation and Maintenance Manual Revision 1 - MAY 2023
63
ESTABLISHING THE OPEN AND CLOSE LIMITS
Establishing the OPEN and CLOSE Limits
The LEARN LIMITS display automatically appears after you set the gate weight. To set the open and
close limits, take the following steps:
1. Hold the OPEN button until the gate slides
to full open. Release the OPEN button. Note
that if you go too far, you can press CLOSE to
reverse direction. Press STOP twice to store
the open stop location in memory.
2. Hold the CLOSE button until the gate slides to
full close. Release the CLOSE button, press
STOP twice to store the full close location in
memory.
Note:
Pressing the OPEN button will reverse
direction.
3. GATE CLOSED appears on the display and
ALERT 15 flashes until the target magnet is
installed and its location stored in memory.
See “Installing the Target Magnet” on page
66 .
Figure 12. Open and Close Limits
Do not install the target magnet
before setting the OPEN and CLOSE
limits. If the target magnet is installed
before setting the limits, the location
of the sensor hole in the beam may
be incorrect and additional holes
or repairs to the gate beam may be
required to relocate the target magnet.