Wallace Perimeter Security ALPHA, Руководство по установке и обслуживанию

Страница: 106 / 182

106
wallaceperimetersecurity.com
Phone: 866.300.1110
INSTALLER MENU FUNCTIONS
INSTALLER MENU FUNCTIONS
Table 6. SmartDC Controller - Installer Menu Functions
Ref.
No�
Installer Menu Setting Options
( Bold = Factory Settings) Menu Tasks and Explanations
Associated
DC Controller
Connections
Display
1
OT 0
SET OPERATOR TYPE
0 = operator type
15 = Kinetic 1 (DC 15)
& Solar
16 = Kinetic 2 (DC 10F)
& Solar
Select the appropriate number for the
operator. Note: This menu item only
appears if the SmartDC Controller is
being replaced.
CAUTION: If you are replacing an
SDC board, remember to transfer the
operator’s menu settings from the
existing board to the replacement board.
Refer to the installation instructions that
accompany the replacement SDC board.
Not applicable
(N/A)
2
LL 0
LEARN LIMITS
0 = Normal operation
1 = Reset limits
A setting of 1 places the operator into its
learn limits mode which allows you to
reset the gate’s open and close positions.
Refer to “Resetting the OPEN and CLOSE
Limits” on page 99 .
(N/A)
3
UC 0
USAGE CLASS
0 = Gate disabled
1 = Residential 1 to 4 units
2 = Comm./public access
3 = Light industrial
4 = Industrial secure
Assign the operator’s Usage Class
designation per UL 325 standards. See
“Identifying Gate Operator Category and
Usage Class” on page 27 . The installer
must designate a usage class before the
operator will function. See “Programming
the Initial Setup Menu” on page 61 .
(N/A)
4
SH 0
GATE HANDING
0 = Gate disabled
R = Right hand
L = Left hand
The handing determines which way the
gate opens as you view it from the secure
side. The installer must designate a left
or right handing before the operator will
function. See “Programming the Initial
Setup Menu” on page 61 .
(N/A)