17.6 lbs.
(8 kg)
DVD WALL MOUNT
B
S
17.6 lbs.(8 kg) including
CS201
WARNING
●Do not begin the installation of the product before you have r
ead amd understood the
instructions and warnings contained in this installation sheet.
if you have any question
regarding any of the instruction or warning, please contact you
r local distributor
●Please refer to installation guide recommendation for required
distance from wall to
avoid risk of property damage.
●This product should only be installed by someone of good mecha
nical aptitude,with
experience and basic building, and fully understands.
●Make sure that the supporting surface will safely support the
combined load of
the equipment and all attached hardware and components.
●If mounting to wood wall studs, make sure that mounting screws
are anchored
into the center of the studs. Use of an “edge to edge” stud fin
der is highly recommended.
●Always use an assistant or mechanical lifting equipment to saf
ely lift and position
equipment.
●
T
ighten screws firml y, but do not over tingten. Over tightening can damage the
items, greatly reducing their holding powe
r
.
●This product intended for indoor use onl
y. Using this product outdoors could
lead to product failure and personal injur
y
.
！
●Never exceed the maximum load capacity.
IMPORTANT:
Ensure you have received all
parts against the component
checklist prior to installing. If
any parts are missing or faulty,
call the franchiser for a replacement.
connect piece(x1)
D
ST5.5x50(x2)
concrete anchor(x2) M5x14(x3)
plastic bush(x1)
plastic cover(x2)
3mm allen key(x1)
A
B
C
G
E
F
Tools required
●Phillips Head Screw driver
(200mm length exclude the handle)
●Electric drill and 8mm masonry bit for
concrete wall installation
●Marking Pen
●Hammer
WOOD STUD WALL MOUNTING:
1a
●Use a stud finder to locate the edges of the studs. Use of an
edge-to-edge stud finder is highly recommended.
Based on their edges, draw a vertical line down each stud’s center.
●Place wall plate on wall as a template. And mark the center
of the four mounting holes. Make sure that the mounting holes are
on the centerline of stud.
●Drill four 1/8”(3mm) dia. Holes 1.2”(30mm) deep. Secure it usi
ng
four screws(A), make sure that the wall
plate is level as shown in fig.1.1.
fig.1.1
SOLID BRICK AND CONCRETE BLOCK
MOUNTING:
1b
fig.1.2
●Use the wall plate as a template to mark four holes locations on the wall as
shown in fig.1.2.
●Pre-drill these holes with a 8mm masonry bit and depth is at least 50mm
.
Insert a Concrete Anchor(B) into each of these holes. Attach the wall plate
to the wall using four screws(A), make sure that the wall plate is level
as
shown in fig.1.2.
Assembling The Glass Holder
●Attach the connect piece to the glass holder using two screws and space reserved
3mm as shown in fig.2.1
●Use the same method to assemble the other glass holder
fig.2.1
2
INSTALL ATION MANUAL
glass shelf(x1)
decorative cover(x2)
glass holder(x1)
①
②
④
③
wall plate(x1)
stud
A
B
A
