500.0037-A
5
Technical alterations reserved
6.
Attach a washer to each of the cylinder screws and screw them through the anchoring
sleeve into the drop-in anchor (10mm Allen key) until they line up.
7.
Tighten the cylinder screws to 35 Nm (10mm Allen key), and then tighten them again
to 35 Nm in the same order to be sure.
If the installation material supplied cannot be used owing to the quality of the floor or wall,
installation has to be adapted to the actual conditions. The dowel used must match the
type of quality of the building material to be anchored into (minimum requirements for
threaded rods, screws and dowels M12: Strength grade 8.8, DIN 975 with ISO 7089
discs). Please observ
e the manufacturer’s instructions
Maintenance and care instructions
Your safe is essentially maintenance-free. However, we still recommend carrying out a
lubricating and servicing interval as follows, depending on frequency of use but at least
every 12 months:
●
Lightly oil the hinges using penetrating oil (e.g. Brunox Turbo Spray).
●
Open the door and extend the bolt using the handle, then grease lightly using a
multi-purpose grease (e.g. Motorex 176 GP).
●
The chrome-steel shelf can be cleaned using a standard chrome-steel cleaner (e.g.
Dr. Weigert neoblank spray).
●
The varnished surfaces can be wiped down with a damp cloth.
WARNING:
Do not clean with household chemical products!
Should any mechanical problems or electrical issues occur, please consult your trusted
specialist dealer or contact WALDIS Tresore AG directly.
Safe wall
Anchoring sleeve
Cylinder-head screw
with washer
Building wall /
Building floor
Drop-in anchor
