500.0037-A
3
Technical alterations reserved
2.2.
Anchoring the safe
PLEASE NOTE:
Assembly and anchoring may only be carried out by WALDIS Tresore
AG’s trained staff or by authorised specialists! WALDIS Tresore AG accepts no liability for
damage to people or property in case of incorrect assembly and anchoring.
2.2.1.
Important prior clarification
Check that the building floor and building wall are suitable for installing the safe and that
there are no wires, pipes or similar in the area to be drilled!
In case of doubt, an expert report should be issued to guarantee that the intended
assembly location in the building can withstand the weight of the safe, including its
contents.
2.2.2.
Preparing the safe
Before anchoring through the rear wall, two screw plugs (Allen key 8mm) must first be
removed from the interior of the safe. Before anchoring through the floor, one screw plug
(Allen key 8mm) must be removed from the interior of the safe:
Anchoring sleeve
in the safe wall
Screw plug
Front view
View from above
