Installation
•
This product is intended to be mounted on a 5.72
cm (2.25") to 6.35 cm (2.5")
pipe tower.
•
Can be mounted on both vertical and horizontal
pipes.
Tools needed
1/16" Allen Wrench (not included)
Attach the forks
•
Any longer side of the backplate can be on the top.
•
Attach the forks on the backplate using the four M6
20 mm bolts.
•
Make sure that the forks point upward (longest
finger is on the top).
•
The bolt heads should be fully recessed into the
plate.
Install the clamp
•
Disassemble the clamp in two halves.
•
Pick a location on your tower to mount the racks.
Consider both ease of use, and accessibility. You will
need at least 20-30 cm (8"-12") of straight bar on the
tower.
•
Install the clamp with included rubber insert on the
chosen location. Choose the rubber insert that gives
you the best fit.
•
A small gap between clamp halves will remain when
tightened properly.
Final steps
•
Place the backplate over the mounting clamp and
attach the plates using four M6 60 mm bolts.
•
Backplate can be adjusted to the desired angle.
