Carina Wall Mount IP Speaker User’s Guide Page 9
v
3.0.1.20200827
Getting Started
1.
All Carina devices should be configured within the Carina Event
Manager’s configuration webpages. While it is possible to make
changes at the device’s own webpages, any configuration changes to
the device’s webpages will be
overwritten
by the Event Manager.
2.
Locate and note your Wall Mount IP Speaker’s MAC address. It is
printed on a white sticker located on the rear of the device.
3.
Connect the Wall Mount IP Speaker’s main Ethernet port—labeled
LAN
—to a network using a Power-over-Ethernet (PoE) Ethernet
connection. When connected, it will power on immediately, and the
LINK/ACTV
status LED will begin to blink.
4.
Your Carina Event Manager will automatically detect the
Wall Mount IP
Speaker when you power up and connect to the network via PoE.
5.
On the Event Manager’s Web interface, navigate to the Devices page to
discover your Wall Mount IP Speaker’s IP address. Look for the device
matching the MAC address you just noted.
6.
Following the instructions in the next sections, change Event Manager
settings for your Wall Mount IP Speaker as needed.
7.
To apply changes and settings to your Wall Mount IP Speaker,
save
changes
and
reprovision
your speaker. This is an important step!
Your
changes in Event Manager will not take effect until you have
reprovisioned the endpoint.
