Wahlberg 352.701, Руководство пользователя

Страница: 17 / 32

352-353.805.006
17
Date: 2019-07-02
Connecting the wireless data link
To connect the Track Runner to data:
1. Connect the DMX data output from the DMX controller to the Wireless DMX transmitter
male 5-pin XLR DMX input connector (DMX 512 IN).
2. Connect the DMX output of the transmitter to the DMX input of other equipment or
terminate the link with a 120 Ohm resistor.
3. Power on both the DMX transmitter and the Track Runner
4. Press the “LINK SW” button shortly (<½s) on the DMX transmitter.
5. Secondly press the “LINK SW” button shortly (<½s) on the Track Runner within the next
10s.
The LED’s RF LINK, LINKED, DMX and STATUS (STAT) should now be constant green on both the
DMX transmitter and the Track Runner when timed out after the 10s, and the RF LEVEL on the
receiver will show the strength of the transmitter signal.
The DMX lamp is the green LED, next to the DMX-selectors.
−
Glows constant, when the DMX connection is correct.
−
Flash if the DMX signal is missing or wrongly connected. Note that for mode 0 to 6 no DMX
signal is needed, thus the DMX lamp will blink but the unit will operate as desired.
Changing transmitter station
To change the transmitter station:
1.
Press the ”LINK SW” button for minimum 3s and until all the LED’s RF LINK, LINKED, DMX
and STATUS(STAT) turns off.
2. Press the “LINK SW” button shortly (<½s) on another DMX transmitter station.
3. Secondly press the “LINK SW” button shortly (<½s) on the Track Runner within the next 10s.
Selecting wireless mode (Factory default)
By default, the wireless transmitter is in transmitter mode, and the Track Runner is in receiver
mode. If needed follow this instruction to re-initialize the correct operation mode of the receiver
and transmitters:
1. Press the ”LINK SW” button shortly (<½s) five times, followed by minimum 3s press and the
unit goes into setup mode(changing operation mode).
2. Within the next 15s you may press the “LINK SW” button shortly (<½s) to switch between
the following two operation modes.
a. Fast flashing: Receiver mode
b. Slow flashing: Transmitter mode
3. Finally, to store the selected mode press “LINK SW” button for minimum 3s until the STAT
LED stops flashing, and the unit is now ready for use.