9
805.281.001
Date: March 22
rd
, 2017
Area of use
The Rotator is intended for indoor use only. It is designed for rotating lamps and other electrical
devices at the weight and speed stated in "Technical Data". Any other use of the rotator may
result in a risk of injury of persons or equipment damage. Exceeding the load rating may cause
failure of the equipment.
Use only approved rigging connectors to secure the load to the rotator and do not modify the
shaft as this may damage the rotator and result in a risk of injury of persons or equipment
damage.
Do not modify the rotator. For any modification of your rotator, contact Wahlberg.
It is the customers' responsibility that any local restrictions concerning the use of the rotator are
complied with.
For indoor use only!
Caution! To reduce the risk of electric shock or injury: use indoors only
Caution! To reduce the risk of electric shock, do not expose to rain: store indoors!
Using for the first time
Important! The Rotator 281 must be protected from environmental factors such as physical
shocks and vibration during transportation and storage.
Warning! Read “Safety Information” on page 2 before installing, powering, operating, or
servicing the rotator. Before applying power to the rotator:
Check the Wahlberg Motion Design website at
documentation and technical information about the Rotator 281. Wahlberg user manual
revisions are identified by the revision number in the bottom of each page.
Carefully review the “Safety Instructions” on page 2.
Check that the local AC mains power source is within the rotator power voltage and frequency
ranges.
See “Power cables and power plug” on page 2. Install a Neutrik powerCON TRUE1 NAC3FX-W
power input connector on a suitable power cable. If drawing the power from a mains power
outlet, install a suitable power plug on the power cable.
