3
805.281.001
Date: March 22
rd
, 2017
Before each use
Ensure that the rotator is correctly and safely mounted
Ensure that the attached load is correctly mounted
Warning! Do not use the rotator if any damage or error is found!
Isolate the rotator from power immediately of the power plug or any seal, cover, cable,
or other component is damaged, defective, deformed, wet, or showing signs of
overheating. Do not reapply power until repairs have been completed
Do not expose the rotator to rain or moisture.
Refer any service operation not described in this manual to a qualified technician.
PROTECTION FROM BURNS AND FIRE
Do not operate the rotator if the ambient temperature (Ta) exceeds 40° C (104° F).
Do not modify the rotator in any way not described in this manual.
Install only genuine Wahlberg parts.
PROTECTION FROM INJURY
Fasten the rotator securely to a fixed surface, rig, or structure when in use. The rotator is
not portable when installed.
Ensure that any supporting structure and/or hardware can hold at least 10 times the
weight of all the devices they support
If suspending from a rigging structure, fasten the rotator using the supplied Manfrotto
slim coupler and M12 bolt, nut, and washers supplied with the rotator according to the
manual, see page 10.
Always install the rotator as described in this manual. If the rotator is installed in a
location where it may cause injury or damage if it falls, install as described in page 10.
If possible, allow enough clearance beneath the rotator so it cannot cause any danger to
personnel beneath it. Else, adjust the lower limit accordingly following the instructions in
this manual.
Check that all external cobblers and rigging hardware are securely fastened.
Block access below the work area and from a stable platform whenever installing,
servicing or moving the rotator.
Do not operate the rotator with missing or damaged covers, shields, or shaft.
