17
805.281.001
Date: March 22
rd
, 2017
Setup
Warning! Read “Safety Information” on page 2 before installing, powering, operating, or
servicing the Rotator 281.
Warning! Only experienced DMX users should operate the rotator. Contact Wahlberg for
further information and education on DMX protocol.
MODE setting
The MODE setting allows you to operate the rotator in
different ways. Each MODE setting has a given function.
Each mode gives an opportunity for different run settings
of the rotator. The MODE is selected using the MODE
selector on the rotator.
The rotator needs to be reset, before the positioning MODE is possible. The rotator must be
reset each time its power supply has been disconnected.
Read the passage about controlling the clockwise (CW)-end- and counter clockwise (CCW)-end
positions, to explore and setup the rotator best for your own particular need.
Warning! Only operate the rotator when there is a clear view to the rotator and area
beneath/above or besides it, depending on the method used for mounting.
Warning! Before running the rotator, ensure that the ‘danger zone’ next to the rotator is
cleared so no people can be harmed.
Warning! MODE 7 and MODE 8 is only for service and tests!
Warning! Before running the rotator in MODE 7 or MODE 8, ensure that the area beneath the
rotator is cleared so no people can be harmed.
MODE 0 – Not used, Motor stops
MODE 1 – Slow Speed Change (Ramp)
Positioning mode with slow ramp
MODE 2 – Normal Speed Change (Ramp)
Positioning mode with medium ramp
MODE 3 – Fast Speed Change (Ramp)
Positioning mode with fast ramp
