2
805.281.001
Date: March 22
rd
, 2017
Safety Information
The following symbols are used to identify important safety information on the product an in
this manual:
This product is for professional use only. It is not for household use.
This product presents risks for sever injury or death due to fire hazards, electric shock, and falls.
Read this manual before installing, powering or servicing the rotator; follow the safety
precautions listed below and observe all warnings in this manual and printed on the rotator. If
you have questions about how to operate the rotator safely, please contact you Wahlberg
Motion Design supplier or Wahlberg Motion Design.
PROTECTION FROM ELECTRIC SHOCK
Disconnect the rotator from AC power before removing or installing any cover or part
and not when in use.
Always ground (earth) the rotator electrically.
Use only a source of AC power that complies with local building and electrical codes and
has both overload and ground-fault (earth-fault) protection.
Before using the rotator, check that all power distribution equipment and cables are in
perfect condition and rated for the current requirements of all connected devices.
Power input throughput cables must be rated 16 A minimum, have three conductors 1.5
mm
2
(AWG16) minimum conductor size and an outer cable diameter of 5-15 mm (0.2-
0.6 inch). Cables must be hard usage type (SJT or equivalent) and heat-resistant to 90
°
C
(194
°
F) minimum. In the EU the cables must be <HAR> approved or equivalent.
Use only Neutrik powerCON TRUE1 NAC3FX-W cable connectors to connect to power
input sockets. Use only Neutrik powerCON TRUE1 NAC3FX-W cable connectors to
connect to power throughput sockets.
Assembly power supply cables following the instructions in this manual only (see page
12).
