System Update on the WAGO-I/O-IPC via CF Card • 17
"Setupmenu.sh" Update Tool
WAGO-I/O-IPC
Hostname : [thinkioc]
After entering a hostname, use the <ENTER> key to accept that name.
The IP configuration is set as follows:
IP Configurations:
bootp: Automatic address setup (via BOOTP)
dhcp: Automatic address setup (via DHCP)
rarp:
Automatic address setup (via RARP)
fix:
Static address setup
Type new IP configuration method [bootp]
=> fix
To configure a fixed IP address, select "fix" and submit.
Then the desired network parameters can be entered and submitted.
Host IP-Address : [193.102.136.90]
=>
192.168.0.7
Server IP-Address : [0.0.0.0]
=>
0.0.0.0
Gateway IP-Address : [0.0.0.0]
=>
0.0.0.0
Netmask : [255.255.255.0]
=>
255.255.255.0
DNS Nameserver 1 IP-Address (Enter
´
.
´
for none) :
Domain name (Enter
´
.
´
for none) :
With this, the configuration of the Ethernet interface eth0 (X9) is completed.
The new parameters will take effect once the device has been restarted.
If desired, a fixed IP address can be assigned to the second Ethernet interface
eth1 (Port X8)
as shown below.
Enable ETH1 Host IP-Address for eth 1 (Y/N) : [N] => n
If the second Ethernet interface doesn't need to be configured yet, this request
will be negatively acknowledged to complete the configuration.
The network settings can be modified at any time using the Web-based
management system of the WAGO-I/O-IPC.
Once the network configuration has been successfully completed, the main
menu is displayed for further settings or to exit the setup program.
4.2.4 “UPDATE” Submenu
By selecting =>
u
(UPDATE) from the main menu, the following submenu
will be displayed, which allows you to modifiy individual WAGO I/O-IPC
software components.