MCS-MAXI Advanced User Guide V1.0
MCS-MAXI Kit Contents (Kit Part Number: 2013008)
Part Number
Product Code
Description
2011254_12X2
MCS-T16
Handset
2011040
MCS-CCE
Crossover Cable Extension Adapter
2012074
MCS-FRC_5000
5m Flat Ribbon Crossover Cable
2012054
MCS-6E (x2)
6 Way Expansion Module
2012079
MCS-HCK
Handheld Clip Kit
2013029_300
MCS-LNK Wire CAN link (300 mm)
2013008_DECV1
MCS MAXI Decal Set
Setting the MCS-6E Address
•
Press and hold button 'B‘ for approximately 5 seconds, until the red LED
on OP1 turns on. (either flashing or steady) Do not let go the button!
Continue holding for another five seconds. The 4 status LEDs will then
turn on, either steady or flashing.
•
Press button 'A' to change the address. If an LED is flashing, the number
above it is ignored. Add the number of all the LEDs that are 'Steady On'
and this will then become the address of the module.
(Example: If LED 1 is steady, LED 2 is flashing and LED 4 is steady on, then add 1 and 4: The
address of this module is 5.)
•
Press button 'B' to save the address, then cycle the power.
2011040
2012074
Notes
•
Door Input: When this input changes from 0V to 12V, if Combo 1 is active then Combo 1 will be deactivated and Combo 2 Activated.
•
Clear All Input: Grounding this input (0V) will deactivate all buttons and combinations. Buttons will be inhibited as long the input remains grounded.
•
Ignition Input: Keeping this input active (12V) will prevent the handset from sleeping. The handset will normally go to sleep if no buttons or combos are active for 60 seconds.
•
Sidelight/Inhibit Input: When this input is active (12V) output 3 is inhibited. (Note: Even if the output is inhibited, the handset button will remain illuminated when selected.)
•
Illumination Input: When this input is active the handset is dimmed.
•
Brake / Inhibit: While this input is grounded (0V) output 6 is enabled. When it is disconnected, or connected to 12V the output is inhibited. (Note: Even if the output is inhibited, the handset button will
remain illuminated when selected. This function can be enabled\disabled in the setup menu.)
Changing the MCS-6E Current Limits
•
Press and hold button 'B' for approximately 5 seconds, until the red
LED on OP1 turns on. (either flashing or steady)
•
Release button 'B'.
•
Pressing button 'A' will then cycle between 5A limit (flashing) and 10A
(steady on).
•
Pressing button 'B' will then cycle to the next output.
Cycle through the outputs, selecting the current limit as required.
Once you are finished changing settings, reset the device by pressing
the reset button, or cycling the power.
2011040
