214 Appendix
WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
“Actually configured Trap Receivers” Group
Table 117
: WBM “Configuration of SNMP v1/v2c Parameters” Page – “Actually Configured Trap
Receivers” Group
Parameters
Meaning
Each configured trap receiver has its own area in the display. If no trap receiver
has been configured, “(no trap receivers configured)” is displayed.
IP Address
The IP address for the trap receiver (management
station) is displayed.
Community Name
This displays the community name for the trap
receiver configuration. The community name can be
evaluated by the trap receiver.
Version
This displays the SNMP version, via which the traps
are sent: v1 or v2c (traps higher than v3 are
displayed in a separate form).
Add new Trap Receiver
In this area, you can enter a new trap receiver.
IP Address
Specify the IP address for the new trap receiver
(management station).
Community Name
Specify the community name for the new trap
receiver configuration. The community name can be
evaluated by the trap receiver.
The community name can be up to 32 characters
long and must not include spaces.
Version
Specify the SNMP version that will send the traps:
v1 or v2c (traps higher than v3 are configured in a
separate form).
Click the corresponding
[Delete]
button to delete an existing trap receiver.
Click the
[Add]
button to add a new trap receiver.
The changes only take effect after the controller restarts. For this purpose, use
the WBM reboot function. Do not shut down the controller too early!
