WAGO I/O System 750
Appendix 213
750-8210/040-000 PFC200; G2; 4ETH; XTR
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
15.2.1.2.23
“Configuration of SNMP v1/v2c Parameters” Page
T
he general settings for SNMP v1/v2c are shown on the “Configuration of SNMP
v1/v2c Parameters” page.
“SNMP v1/v2c Manager Configuration” Group
Table 116
: WBM “Configuration of SNMP v1/v2c Parameters” Page – “SNMP v1/v2c Manager
Configuration” Group
Parameters
Explanation
Protocol enabled
It is displayed the SNMP protocol for v1/v2c is
enabled. The local community name is deleted when
the protocol is disabled.
Local Community Name
Specify the community name for the SNMP
manager configuration. The community name can
establish relationships between SNMP managers
and agents who are respectively referred to as
“Community” and who control identification and
access between SNMP participants.
The community name can be up to 32 characters
long and must not include spaces.
To use the SNMP protocol, a valid community name
must always be specified. The default community
name is “public.”
Click the
[Submit]
button to apply the changes. The changes only take effect
after the controller restarts. For this purpose, use the WBM reboot function. Do
not shut down the controller too early!
