0787-1216
Connection
28
Product manual | Version: 1.0.0
Compact Power Supply
5.1 Connectors
The supply lines are connected on the input or primary sides and on the output or sec-
ondary sides with WAGO's 2092 Series
picoMAX
®
Pluggable Connectors (see
8
Table 27: Connectors
Input side
Output Side
WAGO Connectors
picoMAX
®
5.0
picoMAX
®
5.0
Connection
3-pole:
“L”, “N” and “PE”
4-pole:
twice “+” and “-”
5.1.1 Conductor Termination
WAGO's spring pressure connections are designed for solid or fine-stranded wires with
and without ferrules.
Note
Connect only one conductor per connector!
You must only connect one conductor to each spring clamp connection. Do not connect
more than one conductor at a single connection!
If more than one conductor must be routed to one connection, these must be connected
in an up-circuit wiring assembly, for example, using WAGO Through Terminal Blocks.
Connecting Using a Tool
You must use a screwdriver or an operating tool to connect the following conductors:
• Fine-stranded conductors without ferrules
• Fine-stranded conductors with ferrules without plastic collars with a cross-section
≤ 0.5 mm²/AWG 22
Proceed as follows:
1. To open the spring pressure connection, depress the orange integrated push-button
with a tool.
2. Insert the conductor into the corresponding connection opening.
3. To close the spring pressure connection, release the push-button. This secures the
conductor.
Direct Insertion of Connectors
The following conductors can be inserted directly without tools:
• Fine-stranded conductors with ferrules and plastic collars for all permissible cross-sec-
tions
• Fine-stranded conductors with ferrules without plastic collars with a cross-section
> 0.5 mm²/AWG 22
• Solid conductors with a cross section > 0.25 mm²/AWG 24
5.1.2 WAGO picoMAX® Pluggable Connectors
WAGO’s
picoMAX
®
Pluggable Connectors allows you to prewire products to expedite
product installation and avoid rewiring during product replacement.