765-1103/100-000
Commissioning
Product manual | Version: 2.2.0
67
16DO FLD PN DC 24V 2.0A
The firmware update procedure is as follows:
1. The firmware from the
FWUPDATE.ZIP
firmware container file is stored in the mod-
ule’s flash memory.
2. An internal reset is triggered.
3. Then the device maintenance firmware starts; this edits the firmware container file
and installs the new firmware, including the module’s configuration files.
4. You are notified when the installation procedure finishes.
5. The module then resets again.
6. The new firmware that has just been loaded starts.
10.3.1.4.5 Resetsetting the Module to the Factory Settings
In many cases, it can be helpful to reset the module to the factory settings. This can be
done for various selectable classes of settings with the
Settings
menu item on the
Fac-
tory reset
tab.
Figure 21:
Settings
Menu Item,
Factory Reset
Tab (Example View)
Changes to settings require operator or admin rights. If you do not have these, the
Set-
tings
tab is grayed out and cannot be edited.
Various settings can be reset according to the radio button selection:
Table 37: Options for Resetting the Module to the Factory Settings
Option
Reset Settings
Reset Device Informa-
tion
Module settings (e.g., maintenance information, system time settings)
Reset Network Adapter
Settings
Network adapter settings (communication settings, IP address configuration, sta-
tion name)
Reset Application Pa-
rameters
Application-specific data (port configuration and parameters, remanent parame-
ters)
Reset All
All Settings
To reset the module to the factory settings, proceed as follows:
