WAGO 762-5/8000-000 Series, Руководство пользователя

Страница: 134 / 202

134 Commissioning Touch Panel Advanced Line
762-5xxx/8000-000x TP 600
Manual
Version 1.3.0
8.5.3.34 “Configuration of SNMP v1/v2c Parameters” Page
The general settings for SNMP v1/v2c are shown on the “Configuration of SNMP
v1/v2c Parameters” page.
8.5.3.34.1 “SNMP v1/v2c Manager Configuration” Group
Table 99: WBM “Configuration of SNMP v1/v2c Parameters” Page – “SNMP v1/v2c Manager
Configuration” Group
Parameter Explanation
Protocol enabled
It is displayed the SNMP protocol for v1/v2c is
activated. The local community name is deleted
when the protocol is deactivated.
Local Community Name
Specify here the community name for the SNMP
manager configuration. The community name can
establish relationships between SNMP managers
and agents who are respectively referred to as
“Community” and who control identification and
access between SNMP participants.
The community name can be up to 32 characters
long and must not include spaces.
To use the SNMP protocol, a valid community name
must always be specified. The default community
name is “public.”
Click [Change] to apply changes. The changes only take effect after restarting
the controller. For this purpose, use the WBM reboot function. Do not shut down
the controller too early!
8.5.3.34.2 “Actually Configured Trap Receivers” Group(s)
Table 100: WBM “Configuration of SNMP v1/v2c Parameters” Page – “Actually Configured Trap
Receivers” Group
Parameter Explanation
Count This displays number of configured trap receivers.