WAGO-I/O-SYSTEM 750
Commissioning
95
753-668/000-004 4FAI 0/4-20 mA Diff PROFIsafe
Manual
Version 1.0.0, valid from HW/SW Version 01/01
Figure 35: Start View of the WAGO Safety Editor
8.3.1
ONLINE Mode
ONLINE mode is used to change the iParameter settings of a F I/O module
directly.
8.3.1.1
Reading iParameters from Module or Parameter File
When launching the WAGO Safety Editor, the current iParameter set of the F I/O
module is read from permanent memory of the F I/O module and displayed in the
Input
column of the iParameter set table in the WAGO Safety Editor.
To access existing parameter files, click the
[Open]
button in the WAGO Safety
Editor toolbar.
In the
Open WAGO iParameter set
dialog, select the folder from which the file
should be loaded and enter a name for the parameter file. To load this file from
the hard disk, click the
[Open]
button.
The
iParameter Set Description
dialog also opens. In this dialog, verify the
information given on the project, on the changes made, and on the personnel in
charge and change the information if need be. Click
[OK]
to confirm the entries.