30 Function Description
753-1630 SMI Master Module 230 V AC
Manual
Version 1.2.0 FW/HW Version 02/01
Table 14: Behavior of SMI Drives and Curtains with Button Presses
Function
Behavior of SMI Drives
Behavior of Curtains
Long button
press
SMI drives are moved to the end
position.
Curtains are moved up or down
completely.
Slats are opened or closed
completely.
Short button
press when
stopped
SMI drives are rotated by the
configured angular degree.
Curtains are moved up or down
by the configured increment.
Slats are adjusted by the
configured angular degree.
Short button
press when
moving
SMI drives are stopped.
Curtains are stopped.
Slats remain in the current
position.
Pos: 71.6 /Serie 753 (WAGO-I/O-SYSTEM)/Funktionsbeschreibung/Funktionsbeschreibung 753-1630, -1631/Funktionsbeschreibung 753-1630, -1631 - Feldbuskopplermodus -Positionieren von Behängen und Lamellen @ 28\mod_1478704015085_21.docx @ 386520 @ 3 @ 1
4.1.5
Positioning Curtains and Slats
The position of a shutter is determined by the shutter position and slat position.
The shutter position is a position in the total adjusting range of shutters between
the top and bottom end positions of the drive.
The slat position is a position between fully open and fully closed slats in the slat
adjusting range (total travel range).
Both values are specified in percent.
The shutter position is adjusted first. The slats are then positioned. The slats are
always positioned from the fully open slat position that is reached by moving
upwards. The distances of this motion can be individually set by configuring the
positioning offset for each shutter. The adjusting range of the slats must be less
than the positioning offset.
