WAGO-I/O-SYSTEM 750
Commissioning 159
750-8207 PFC200 CS 2ETH RS 3G
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
7.8.1.37 “Configuration of OpenVPN and IPsec” Page
The general settings for SNMP v1/v2c are shown on the “Configuration of SNMP
v1/v2c Parameters” page.
7.8.1.37.1 “OpenVPN” Group
Table 107: WBM “Configuration of OpenVPN and IPsec” Page – “OpenVPN” Group
Parameters
Explanation
Current State
The current status of the OpenVPN service is
displayed.
stopped The service is disabled.
running
The service is enabled.
OpenVPN enabled
Enable or disable the OpenVPN service.
openvpn.config
Select an OpenVPN configuration file to be
transferred from PC to controller or vice versa.
To apply a status change, click the
[Submit]
button.
To select a file on the controller or PC, click the
[Browse]
button.
To transfer the selected file from the PC to the controller, click
[Start Upload]
button.
To transfer the selected file from the controller to the PC, click
[Start Download]
button.
The changes only take effect after restarting the controller. For this purpose, use
the WBM reboot function. Do not shut down the controller too early!
7.8.1.37.2 “IPsec” Group
Table 108: WBM “Configuration of OpenVPN and IPsec” Page – “IPsec” Group
Parameters
Explanation
Current State
The current status of the IPsec service is displayed.
stopped The service is disabled.
running
The service is enabled.
IPsec enabled
Enable or disable the IPsec service.
ipsec.config
Select an IPsec configuration file to be transferred
from PC to controller or vice versa.
ipsec.secrets
Select an IPsec configuration file to be transferred
from PC to controller.
To apply a status change, click the
[Submit]
button.
To select a file on the controller or PC, click the
[Browse]
button.
To transfer the selected file to the controller, click
[Start Upload]
button.