WAGO-I/O-SYSTEM 750
Operating Modes
51
750-484 2 AI 4-20 mA HART Ex i
Manual
V 1.2.0 HW-Version 04, SW-Version 03
Fieldbus Node must be without power!
The Communication cable 750-920 shall not be connected or removed when the
system is energized; i.e., there shall be no power to the coupler/controller!
2.
After installing WAGO-I/O-
CHECK
via the installation wizard, open it.
3.
Go to the
Settings
menu and click
[Communication].
A “Communications settings” dialog box will open.
In this window under
Connection
select “Serial ports (COM, USB,
Bluetooth, ...)” and under
Port
“COM1: Communications port”.
Then confirm this selection by clicking
[OK].
4.
Switch on the supply voltage to your coupler/controller.
5.
When the coupler/controller has booted up click
[Identify]
on the toolbar.
The set-up of your fieldbus node will be automatically detected and shown
graphically in the node view and also in the navigation bar as a tree
structure.
6.
Move the mouse pointer to the graphical representation of the HART I/O
module or to the I/O module designation "0750-0484" in the tree structure
and select "Settings" from the context menu (right mouse button).
Figure 16: WAGO-I/O-
CHECK
Context Menu „Settings“
7.
In the dialog window that opens for making the settings select the required
operating mode and then click "Write".
