WAGNER W 500, Перевод оригинальной инструкции по эксплуатации

Страница: 33 / 78

GB
25
W 500
•
Place the container on a paper base and pour in the prepared coating substance with
the aid of the feed hopper included in the scope of supply (Fig. 1, 18).
Screw the container tightly onto the spray gun.
•
Connect the front part with the rear part of the gun. (Fig. 5)
•
Mount the air hose (Fig. 4, a + b). Insert the air hose firmly into the connection of the
unit and the gun handle. The position of the hose is not relevant.
•
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
•
Sling on the carrying strap with the unit.
•
Press the ON/OFF switch at the device.
12. Settings on the ON/OFF switch
The W 500 has a multi-stage On/Off switch. This allows the power of the unit to be adjusted
to the material used, in order to optimise the spray pattern and reduce the spray mist.
Switch in Position
"0"

Unit switched off
Switch in Position
"1"

Unit switched on to speed stage 1
(for working with very thin materials)
Switch in Position
"2"

Unit switched on to speed stage 2
(for working with more viscous materials)
i
For thin materials the spray mist can be reduced and energy saved by
switching to speed stage 1.
13. Selecting the Spray Setting (Fig. 6)
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
2 different spray jet shapes can be set by turning the adjustment ring (fig. 6, 1)
Fig. 7 A = vertical flat jet

for horizontal surfaces
Fig. 7 B
= horizontal flat jet

for vertical surfaces
Use the red adjustment lever to also switch between a wide ( )
and a narrow ( ) spray jet.