WAGNER TOPFINISH Bell 1S, Перевод оригинального руководства по эксплуатации

Страница: 59 / 80

59
VERSION 01/2018 ORDER NUMBER DOC 2385674
TOPFINISH Bell 1S
10 REPAIR WORK
10.1 REPAIR PERSONNEL
Repair work should be undertaken carefully by qualified and trained personnel. They
should be informed of specific hazards during their training.
The following hazards may arise during repair work:
– risk to health from inhaling solvent vapors,
– use of unsuitable tools and aids.
A skilled person must check to ensure that the device is in a reliable state after it is repaired.
10.2 REPAIR NOTES
DANGER
Incorrect maintenance/repair!
Danger to life and equipment damage.
Only a WAGNER service center or a suitably trained person may carry out repairs and
replace parts.
Use only WAGNER original spare parts and accessories.
Only repair and replace parts that are listed in the "Spare parts" chapter and that are
assigned to the unit.
Before all work on the device and in the event of work interruptions:
- Relieve the pressure from the high-speed rotary atomizer, high-pressure hoses and
all devices.
- Secure the high-speed rotary atomizer against actuation.
- Switch off the energy and compressed air supply.
- Disconnect the control unit from the mains.
Observe the operating and service manual for all work.
Before Repair Work
– Flush and clean the system according to Chapter 8.1.2 .
− Interrupt the air supply.
After Repair Work
– Carry out safety checks in accordance with Chapter 8.2.3 .
– Put the system into operation and check for leaks as described in Chapter 6.9 .
− Have the system checked for safe condition by an authorized person.
– Function test in accordance with Chapter 11 .