WAGNER POWERPAINTER 90 EXTRA, Руководство пользователя

Страница: 12 / 20

22
PowerPainter 90 EXTRA Skid GB
Assembly
1. Remove the protective covers on the hose and hose connection. (Fig. 2)
2. Screw the pressure gauge to the hose connection.
3. Screw the high pressure hose onto the pressure gauge.
Keep hold of the connection using an adjustable spanner and tighten the hose connection with another spanner. (Fig. 3)
4. Screw the thread at the other end of the hose to the spray gun connection. Keep hold of the spray gun by applying an adjustable
spanner to the handle and tighten the hose nut using another spanner. (Fig. 4)
5. Place the nozzle holder on the spray gun (Fig. 5A ) and rotate it into the final position (Fig. 5B), in order to fix it.
6. Pull the red shutter out of the paint entry point. (Fig. 6, 1)
7. Connect the suction hose to the paint entry point and secure into position. (Fig. 6, 2 and 3)
8. Push the return line on to the return flow connector. (Fig. 7)
Control elements on the device (Fig. 8)
A The ON/OFF switch turns the power to the sprayer on and off (0=OFF, l=ON).
B The following settings can be made with the selector switch:
PRIME (Switch set vertically)
Æ
•
For prefilling the system with paint
•
For pressure relief
SPRAY (Switch set horizontally)
Æ
•
For using the spray gun
C The pressure of the spray is set by the pressure regulator.
The correct spray pressure depends on the paint being used.
Spray Gun
Danger
Always lock the trigger off when attaching the spray nozzle or when the spray gun is not in use.
•
To lock the trigger, push in the trigger lock from left to right, when looking at the rear of the gun. (Fig. 9, A)
•
To unlock the trigger, push the trigger lock from right to left, when looking at the rear of the gun. (Fig. 9, B)
•
Insert the nozzle with the tip pointing forwards. (Fig. 10)
i
Another nozzle size and gun filter must be used, depending on the material to be processed.
Information about all the available nozzles and filters can be found in the section about "Accessories".
Pressure Relief Procedure
Danger
Be sure to follow the Pressure Relief Procedure when shutting the unit off for any purpose.
This procedure relieves the pressure from the spray hose and the gun.
1. Secure the spray gun. (Fig. 9, A)
2. Switch the device off.
Turn the switch into the PRIME position (vertical). (Fig. 11)
3. Release the spray gun. Hold the spray gun over an empty container and press the trigger to relieve the pressure.
4. Secure the spray gun.
Start-up
Before connecting to the mains supply, be sure that the supply voltage is identical with the value given on the rating
plate.
1. Spray a little oil out of the provided flask into the marked opening (fig. 12, 1). Tip: tilt the device back.
Light household oil can be substituted if necessary.
2. Disconnect the return flow pipe from the suction hose.
3. Place the suction hose (Fig. 12, 2) in the material container and the return line (Fig. 12, 3) in an empty container.
4. Press the red inlet valve pusher to ensure that the inlet valve is free. (Fig. 13)
5. Plug in the power cable.
6. Turn the switch into the PRIME position (vertical).
7. Hold the return line over the empty container and switch the device on.
This will flush out any preservative remaining in the system.
8. Switch the device off again as soon as material emerges from the return line.