WAGNER LineCoat 800, Руководство по эксплуатации

Страница: 29 / 94

LineCoat 800 27
GB
Operation Painting
Earth the gun by holding it against the edge of the
metal container while flushing. Failure to do so
may lead to a static electric discharge, which may
cause a fire.
16. Trigger the gun into the metal waste container until the old
solvent is gone and fresh solvent is coming out of the gun.
17. Lock the gun by turning the gun trigger lock to the locked
position.
18. Set down the gun and increase the pressure by turning
the pressure control knob slowly clockwise to its highest
setting.
19. Check the entire system for leaks. If leaks occur, turn the
sprayer off and follow the “Pressure Relief Procedure” in
this manual before tightening any fittings or hoses.
20. Follow the “Pressure Relief Procedure” (section 4.2) in this
manual before changing from solvent to paint.
Be sure to follow the pressure relief procedure
when shutting the unit down for any purpose,
including servicing or adjusting any part of the
spray system, changing or cleaning spray tips, or
preparing for cleanup.
4. Painting
1. Place the siphon tube into a container of paint.
2. Place the return hose into a metal waste container.
3. Turn the pressure control knob fully counterclockwise to
its lowest pressure setting.
4. Move the PRIME/SPRAY valve to the PRIME position.
5. Move the engine ON/OFF switch to the ON position.
6. Start the engine (fig. 8):
a. Open the fuel valve lever (2).
b. Move the throttle lever away from the gas tank (3).
c. Close the engine choke lever (4).
d. Holding the frame with one hand, pull the starter rope
(5) rapidly and firmly. Continue to hold the rope as
you let it return. Pull and return the rope until the
engine starts.
2
4
1
3
5
7. Turn on the sprayer by moving the pump ON/OFF switch
to the ON position (fig 9, 1).
8. Slowly turn the pressure control knob (fig. 9, 2) clockwise
to increase the pressure until fluid starts to come out of the
return hose. Use only enough pressure to keep the fluid
coming out.
1
2
9. Allow the sprayer to run until paint is coming through the
return hose into the metal waste container.
10. Turn the pressure control knob fully counterclockwise to
its lowest setting.
11. Turn off the sprayer by moving the pump ON/OFF switch
to the OFF position.
12. Remove the return hose from the waste container and place
it in its operating position above the container of paint.
13. Move the PRIME/SPRAY valve to the SPRAY position.
14. Turn on the sprayer.
15. Turn the pressure control knob slowly clockwise to
increase pressure.
16. Unlock the gun by turning the gun trigger lock to the
unlocked position.