WAGNER LineCoat 800, Руководство по эксплуатации

Страница: 27 / 94

LineCoat 800 25
GB
Operation
3. Operation
This equipment produces a fluid stream at
extremely high pressure. Read and understand
the warnings in the Safety Precautions section at
the front of this manual before operating this
equipment.
3.1 Setup
Perform the following procedure before starting the engine of a
gas-powered line striper.
1. Ensure that the siphon hose and the return hose are
attached and secure.
2. Position the spray gun (fig. 2).
a. Loosen the support bar clamp hex screw (1) and
rotate the gun support bar (2) to the desired position.
Tighten the hex screw securely.
b. Loosen the gun holder clamp knob (3) and slide the
spray gun to the desired vertical and horizontal (front-
to-back) position. Tighten the knob securely.
2
3
1
3. Turn the pressure control knob fully counterclockwise to
its lowest pressure setting (fig 3, 1).
4. Make sure the pump ON/OFF switch is in the OFF position
(fig 3, 2).
1
2
i
The height of the spray gun affects the width of the
spray pattern (i.e., the lower the gun, the smaller
the line width). Tip size also affects line width.
Attention
Never operate unit for more than ten seconds
without fluid. Operating this unit without fluid will
cause unnecessary wear to the packings.
5. Check the engine oil level. The gasoline engine oil level
is determined by the manufacturer. Refer to the engine
manufacturer’s service manual (supplied).
6. Close the fuel shut-off lever and fill the gas tank with
gasoline. Use only high quality, unleaded gasoline.
i
The gun support bar and the spray gun can be
mounted on either side of the sprayer. To move
the gun support bar:
a. Remove the support bar clamp hex screw and nut.
b. Move the gun support bar to the opposite side of
the cart.
c. Align the support bar clamp with the bracket on the
cart.
d. Thread the clamp hex screw through the gun
support bar clamp and the bracket on the cart.
Place the nut on the end of the clamp hex screw and
tighten securely.
3.2 Adjusting the trigger tension (fig. 4)
Use the following procedure to adjust the spring tension of the
trigger lever on the gun holder assembly. The trigger lever
pulls and releases the spray gun trigger when operated from
the trigger on the cart. The proper tension ensures that the gun
will shut off when the gun trigger is released. To ensure proper
tension, there should be approximately a 1/32” to 1/16” gap
between the trigger lever and the spray gun trigger.
Attention
Always keep the trigger lock on the spray gun in
the locked position while making adjustments to
the system.
1. Using a wrench, loosen the bolt on the cable block (1).
2. Move the cable block in the appropriate direction to create
a gap of 0.8 mm to 1.6 mm between the trigger lever (2)
and spray gun trigger (3).
a. Slide the cable block toward the gun to increase the
gap between the trigger lever and spray gun trigger.
b. Slide the cable block away from the gun to decrease
the gap between the trigger lever and spray gun
trigger.
3
2
0.8 - 1.6 mm
1
3. Tighten the set screw securely.