Operating manual Universal Control Unit for Powder Spray Guns EPG-SPRINT XE
4 Basic Safety Instructions
16
Order number 2354913 | Edition 10/2022
4
Repair or replacement of devices or parts of devices are only allowed to be performed
outside the hazard area by qualified personnel.
4
Use only WAGNER original spare parts and accessories.
4
WAGNER assumes no liability for changes to the product made by the operating
company without the knowledge of WAGNER. Any adjustments to the documentation
and the market release are the responsibility of the operating company.
4
Only repair and replace parts that are listed in the chapters
"
Accessories
"
and
"
Spare
Parts
"
and that are assigned to the device.
4
Do not use any defective components.
4
Before all work on the device and in the event of work interruptions:
4
Switch off the energy and compressed air supply.
4
Relieve pressure on spray gun and device.
4
Secure the spray gun against actuation.
4
Observe the operating and service manual for all work.
4.2.8 Protective and Monitoring Equipment
Danger due to removal of protective and monitoring equipment!
Danger to life and equipment damage.
4
Protective and monitoring equipment must not be removed, modified or rendered
unusable.
4
Regularly check for perfect functioning.
4
If defects are detected on protective and monitoring equipment, the system must not
be operated until these defects are remedied.
4.3 SAFETY FEATURES
Plates bearing information for the user have been attached to the work openings of the
powder coating booth.
The plate size corresponds to standard series Ø 100 mm (3.94 inches).
The label plates, which must be attached, are shown below:
Forbidden for persons with a cardiac
pacemaker!
Forbidden for unauthorized persons!
Smoking, fire, and open flames are pro-
hibited!
Danger of crushing!
Risk of tripping!
High voltage!
In the control cabinet:
(25 mm; 0.98 inch)
Voltage before main switch
Explosive atmosphere!
