13
ENGLISH
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
Problem A: Little or no material flow
1. Nozzle clogged.
2. Suction tube clogged.
3. Material flow setting too low.
4. No pressure build up in container.
5. Air filter clogged.
6. Spray material too thick.
1. Clean.
2. Clean.
3. Increase material flow setting.
4. Tighten container or container lid and
check the clear tube.
5. Change
6. Thin.
Problem B: Material leaking
1. Nozzle loose.
2. Nozzle worn.
3. Material build-up on air cap and nozzle.
1. Tighten.
2. Replace.
3. Clean.
Problem C: Spray pattern too thick, runs
and sags
1. Material flow setting too high.
2. Applying too much material.
1. Decrease material flow setting.
2. Adjust material flow or increase movement
of spray gun.
Problem D: Spray nozzle spits
1. Material in container running out.
2. Air filter clogged.
1. Refill.
2. Change.
Problem E: Too much overspray
1. Gun too far from spray object.
2. Material flow setting too high.
1. Reduce distance (6”-8” is ideal).
2. Decrease the material flow.
Problem F: Pattern is very light and
splotchy
1. Moving the spray gun too fast.
2. Material flow setting too low.
1. Adjust material flow or decrease
movement of spray gun.
2. Increase material flow setting.
This unit contains no servicable electrical parts. Do not attempt to
service yourself. Store indoors with the cord wrapped around the
turbine handle.
Have you tried the recommendations above and are still having
problems? In the United States, to speak to a customer service
representative, call our Technical Service at 1-888-783-2612.
OPTIONAL EXTRAS
Needles and fluid tips of different sizes can be obtained as sets under the following accessory numbers. Please call our toll free helpline
to order these at 888-783-2612.
Part No.
Description
0HV5ACC10US
1.0mm dia fluid tip, needle & seal
0HV5ACC15USR
1.5mm dia fluid tip, needle & seal
0HV5ACC20USR
2.0mm dia fluid tip, needle & seal
0HV5ACC25USR
2.5mm dia fluid tip, needle & seal
0L0190A
Material container, solvent based materials*
*The PTFE coating inside the material container included with the sprayer is meant for water-based materials. For solvent based
materials, especially lacquers, order cup part number 0L0190A for a non-coated material container.
