WAGNER Airless Sprayer Plus 0418, Руководство по эксплуатации

Страница: 25 / 84

25
Airless Sprayer Plus GB
Make pump ready for operation
1) Make sure the inlet filter is in
place inside the hopper. If it
is not, snap in place as shown.
2) Push the tab on top of
the filter down once.
This will ensure proper
operation of the inlet valve.
3) Pull the return tube from
the hopper and hold it over
a waste container.
4) Turn the PRIME/SPRAY knob
to PRIME.
5) Plug in the sprayer, and
move the ON/OFF switch to
the ON position.
Tab
SPR
AY
PRIME
l
Any fluids remaining in the pump and the return tube will
flow out of the return tube. Let the pump run until no fluid
is coming from the return tube.
6) Switch the pump to OFF. Remove the return tube from
the waste container and secure it to the hopper.
O
We recommend performing the following steps with
water first of all, in order to check that the system and all
connections are watertight.
7) Fill your hopper with the
material you plan to spray.
Do not exceed the fill line as
shown. Replace the hopper
lid.
Fill line
8) Leave the PRIME/SPRAY
knob on PRIME and switch
your unit ON once more
and make sure that material
is flowing from the return
tube.
SPR
AY
PRIME
l
Suck in material
Perform the following steps, without the spray tip
mounted to the gun.
1) Unlock the spray gun and
turn the PRIME/SPRAY knob
to PRIME.
2) Trigger and HOLD the spray
gun into a waste container.
3) Switch the pump on.
WARNING
Keep hands clear from fluid
stream.
4) While holding the trigger,
turn the PRIME/SPRAY knob
to SPRAY. Hold the trigger
until all air, water, or solvent
is purged from the spray hose
and paint is flowing freely.
SPR
AY
PRIME
l
SPRAY
PRIME
5) Release trigger, turn the
PRIME/SPRAY knob to
PRIME and turn pump OFF .
SPR
AY
PRIME
O
6) Trigger the gun into the waste container once more to
be sure that no pressure is left in the hose.
7) Lock the spray gun off.
8) Thread the spray tip assembly onto the gun. Tighten by
hand.
Begin
tightening
the tip at
this angle
to achieve
the desired
spray angle
when tight.
9) Insert spray tip (tip pointing in the spray direction).
Your device is now ready for operation.
Preparation