Before setting the programming card, it is
allowed to use any cards/tags to unlock.
L700
ELECTRONIC
HANDLE LOCK
User Manual
Tap the programming card on the reader,
the red light will start flashing for 10 seconds
until "1 long beep sound" followed by the
green light flashing 3 times.
1
Default
Your Warranty covers all manufacturers' defects in
workmanship and material. It does not cover any
unit that is damaged beyond normal usage, by improper
installations, by contacts to chemicals, or any other acts
or omissions unsanctioned within the user manual. All
components are covered for one (1) year after the date
of purchase or installation from supplier. The user is
required to provide dated proof of purchase. Waferlock
or its authorized distributor will determine if there is a
warrantable condition associated with material and/or
manufacturing workmanship. If the lock conforms to the
warranty conditions, the lock will be repaired free of
charge. The shipping freights would be at owner's
expense. The warranty does not include any further
obligation whatsoever, including but not limited to the
installation of the replacement unit to the customer's
lock. All other warranties, express or implied, are
disclaimed. All collateral agreements, which purport to
modify this limited warranty, are of no effect.
This device has been tested to and conforms to the
regulatory requirements of the European Union and has
attained CE Marking. The CE Mark is a conformity
marking consisting of the letters “CE”. The CE Mark
applies to products regulated by certain European
health, safety and environmental protection legislation.
The CE Mark is obligatory for products it applies to: the
manufacturer affixes the marking in order to be allowed
to sell his product in the European market. This product
conforms to the essential requirements of the R&TTE
directive 1999/5/EC in order to attain CE Marking. The
CE Marking is not a quality mark. Foremost, it refers to
the safety rather than to the quality of a product.
Secondly, CE Marking is mandatory for the product it
applies to, whereas most quality markings are voluntary.
Your Warranty
CE Marking
PROGRAMMING
Green X 3
1 “beep” sound
PROGRAMMING
Red
10 “beep” sound
10
s
ec
Note
Emergency External Power Supply
Backup 9V battery contact point is at the front
panel. Connect 9V battery with contact points.
Low Power Warning
If the lock battery is low, there is an acoustic
warning for the user with 3 short beeps 5 times,
followed by red light flashing. Please replace a
new battery to keep lock operating well.
Low Battery Warning
Set Up The Programming Card
WAFERLOCK CORPORATION
Tel: 886-4-24620208 Fax: 886-4-24636286
No. 16 Ke Yuan 2nd Rd., Central Taiwan Science Park
Taichung city 407, Taiwan.
E-mail: [email protected]
Note
If 2 short beeps occur with the red light flashing 2 times,
the setup was not successful. Please re-program.
V01
The Programming Card must be linked to
the lock before any other steps can take place.
1. Within these 10 seconds, do not remove the
programming card away from the reader.
2. Programming card is used to add/delete user
cards/badges, but not be used to unlock the locks.
3. Any MIFARE card will be able to unlock the lock
before it is programmed.
4. There is only ONE programming card per lock.
Please keep it safely.
5. You can use one programming card for multiple locks.
www.waferlock.com
ISO9001 CERTIFIED
