Wadkin Bursgreen WB800H, Руководство пользователя, Страница: 15 / 27

13
A1
N
Tilting the table to perform bevel cuts
To use the table to perform a bevel cut, loosen the
table trunnion locking lever( M ) and turn the table tilt
handle( Z ) to tilt the table over to the desired angle.
Re-secure the locking lever( M ).
Compound mitre cuts can be made by using the
mitre gauge in conjunction with the table tilting
facility.
MAINTENANCE
Changing the blade
Warning! Unplug the machine from the
electrical supply. This ensures that the
bandsaw will not accidentally turn on if the
ON/OFF switch is bumped.
Remove the rip-fence.
Remove the rip-fence rail.
Open both the upper and lower doors.
Turn the blade tension adjustment hand-wheel
( N ) to release the tension (if needed).
Turn the blade tension quick release lever ( A1 )
to fully release the tension of blade.
Remove the blade.
Fit the new blade around both top and bottom
drive-wheels, taking care that the correct size of
blade is being fitted and that the direction of the
blade is also correct.
Caution: Because the blade is an endless
loop it may spring and coil itself into smaller
loops.
Note: The teeth of the blade should be
pointing downwards if the blade has been
fitted in the correct direction.
Return the pressure to the blade by turning the
blade tension quick release lever back to its
original position.
Continue to tension the blade fully by turning the
adjustment hand-wheel.
Replacing the drive belt:
Remove the blade (see above).
Turn the belt tension handwheel to release
tension from the drive belt.
Loosen and remove the drive wheel securing nut
and washer(
A2 ) (located at the rear of the saw).
Z
M