10 Use and operation
100_0101_op_0008.fm
39
10.3
Decommissioning
Switching off the machine
1. Slowly remove the vibrator head from the fresh concrete and hold it in the air.
2. Switch off the machine via the ON/OFF switch.
3. Wait until the machine has come to a complete standstill.
4. Slowly set down the machine (operative position), lay down the associated
flexible shaft and vibrator head.
Note:
Do not kink the protective hose and power cable.
5. Pull the plug from the plug receptacle.
6. Allow for the unit to cool.
Disconnecting the flexible shaft from the drive
1. T-handle.
2. Remove the flexible shaft coupling from the drive coupling.
3. Release the T-handle.
4. Set down the machine securely on a firm and level surface so that the drive
motor cannot tip over, fall or slide away.
CAUTION
The vibrator head moves if it is turned on and not immersed in the fresh con-
crete.
Danger of injury or danger of damage to property by uncontrolled vibrator head.
X
Switch the machine off before you put it down.
CAUTION
The vibrator head heats up if it is turned on and not immersed in the fresh con-
crete.
Hot surface can cause burns.
Damage to the machine with excessive wear.
X
Do not operate the machine with the internal vibrator not immersed in the
fresh concrete.
CAUTION
Risk of burns from hot coupling on the flexible shaft.
X
Always wear protective gloves when holding the coupling.
