Wacker Neuson KRAMER 5055e, Руководство оператора

Страница: 96 / 420

4-24
BA 357-00 * 3.0 * 35700_04_Inbetriebnahme_01.fm
4 Putting into operation
Coding the ignition key
The coding of the new ignition key (blue) is performed
using the master key (red).
The master key can only be used for coding the new ignition key and not
for disabling the immobilizer.
1. Switch on the parking lights
– see chapter 5 “Parking lights/low beam” on page 5-19 .
2. Insert the master key (red) in the ignition lock and turn to position " II ".
3. Turn the master key (red) within 5 seconds to position " 0 " and remove.
4. Insert the ignition key (blue) that is to be coded into the ignition lock,
turn to position " II " and leave it in place for at least 1 second.
➥
The key will be registered as a valid ignition key.
5. Turn the ignition key (blue) back and remove.
➥
Step 4 can now be repeated for other keys to be coded.
➥
Coding can be performed for a maximum 10 keys.
➥
Coding is automatically stopped if no other key
is detected within 15 seconds.
Enabling the immobilizer
1. Turn off the machine
– see chapter 5 “Machine stopping/securing” on page 5-18 .
2. Remove the ignition key (blue).
➥
Immobilizer will be enabled in 30 seconds.
Information
If the ignition key (blue) is not removed from the ignition lock, the
immobilizer will remain disabled!
Disabling the immobilizer
• Insert the ignition key into the ignition lock.
➥
The immobilizer will be disabled after 5 seconds.
• Turn on the machine – see "Turn on the machine" on page 4-54 .
➥
The immobilizer remains disabled so long as
the ignition key is not removed.
Fig. 76
I
0 II
P
III