![Wacker Neuson GP 2600 Скачать руководство пользователя страница 24](http://html1.mh-extra.com/html/wacker-neuson/gp-2600/gp-2600_operators-manual_3132662024.webp)
Operation
GP 2600
wc_tx000558gb.fm
24
3.11 To Start
3.11.1 Ensure that the generator is properly installed in an outdoor location.
See Sections
Installation
and
Operator Safety while using Internal
Combustion Engines
for installation warnings and safety guidelines.
3.11.2 Disconnect all loads from the generator.
3.11.3 Open the fuel valve
(a1)
.
Note:
If the engine is cold, move the choke lever to the closed position
(b2)
.
If the engine is hot, set the choke to the open position (b1)
.
3.11.4 Turn the engine switch to “ON”
(c1)
.
3.11.5 Pull the starter rope
(d)
.
Note: If the oil level in the engine is low, the red LED at the engine
switch will light and the engine will not start. If this happens, check the
oil level and add oil as needed.
3.11.6 Open the choke as the engine warms
(b1)
.
3.11.7 Allow the engine to warm up a few minutes before attaching loads.
3.12 To Stop
3.12.1 Turn off and disconnect all tools and appliances attached to the
generator.
3.12.2 Turn the engine switch to “OFF”
(c2)
.
3.12.3 Close the fuel valve
(a2)
.
Note: To stop the engine quickly in an emergency, turn the engine
switch to “OFF” (c2).
wc_gr002818
Содержание GP 2600
Страница 1: ...Generator Non CARB GP 2600 OPERATOR S MANUAL 0170798en 001 0408 0 1 7 0 7 9 8 E N...
Страница 11: ...GP 2600 Safety Information wc_si000196gb fm 11 2 5 Label Locations GND 88897...
Страница 31: ...GP 2600 Maintenance wc_tx000559gb fm 31 Notes...
Страница 33: ...GP 2600 Maintenance wc_tx000559gb fm 33 ORG ORG BLK BLK wc_gr004573...