Wacker Neuson G 14, Руководство оператора

Страница: 42 / 68

Operation G 14
42
wc_tx001168gb.fm
5 Operation
5.1 Breaking In New Machines
Run the generator at least 60–100% of continuous load for the first 100 hours.
Change engine oil and replace oil filter after the first 50 hours.
5.2 Starting the Generator
Prerequisites Wires at the customer connection lugs are connected for the proper voltage
output. See section
Voltage Output.
Starting key (g) is in the STOP position.
Main line circuit breaker (c) is in the off “O” position.
Convenience receptacle circuit breakers (o, p, q) are in the off “O” position.
Thoroughly review the “Before Starting” checklist in Initial Setup and Overview.
Proceed with generator startup only after checking each item in that section.
Thoroughly read and make sure you understand the engine operator’s manual
supplied with the generator. Follow the steps below in the order listed.
Starting
procedure
Follow the procedure below to start the machine.
1. Turn the starting key clockwise to ON (first position).
2. Turn the starting key to Glow Plug (second position). The glow plug indicator will
illuminate. The glow plugs are now being energized.
3. After approximately five seconds, the glow plug indicator will go out.
4. Turn the starting key to Crank (third position). The engine should start. Release
the starting key when the engine starts.
5. If the engine does not start, return the starting key to the STOP position. Wait
approximately 30 seconds for the starter motor to cool before trying again.
WARNING
Personal injury hazard. Failure to match phase rotation and voltage may cause
equipment connected to the generator to operate incorrectly.
f
When using the generator as a standby or substitute power supply, make sure
the voltage and phase rotation of the line connections match those of the utility
lines or of any other power source normally used.
V Hz
HOUR METER
FUEL
A
A
c
o
p
q
g
wc_gr006212