Wacker Neuson E09-01, Руководство оператора

Страница: 153 / 188

BA 1404 en – Edition 2.7 * 1404b520.fm
5-25
Maintenance
Parking the machine
1 Stop the machine on firm, level, and horizontal ground.
2 Position the boom straight ahead at the center of the machine.
3 Lower the boom and the stabilizer blade to the ground.
4 Stop the engine.
5 Operate the control lever repeatedly to release the pressure in the hydraulic system.
6 Raise the control lever base.
7 Remove the starting key and carry it with you.
Lubricating the ball bearing race of the live ring
Danger
!
Do not rotate the machine during lubrication!
Crushing hazard! Do not rotate the upper carriage during lubrication.
Serious crushing hazard causing death or serious injury.
☞
Do not rotate the upper carriage.
☞
Stop and park the machine – see chapter on page 5-25.
1 Park the machine on firm, level, and horizontal ground.
2 Lower the boom and the stabilizer blade to the ground.
3 Stop the engine, remove the starting key and carry it with you.
4 Raise the control lever base.
5 Apply grease to lubrication point 12 with one stroke of the grease gun.
6 Start the engine, raise the boom and the stabilizer blade.
7 Rotate the upper carriage by 90°.
8 Repeat steps 2 – 7 three times until the upper carriage is back in its initial position.
9 Rotate the upper carriage several times by 360°.
Abb. 206: Parking the excavator
Abb. 207: Lubrication point of ball bearing race
11
Abb. 208: Rotate the upper carriage by 90° at a time