Wacker Neuson DV60, Руководство оператора

Страница: 101 / 212

BA D24 en/us* 1.0 * D24_1_0_400.fm
4-39
Putting into operation 4
Starting the engine
1. Sit down on the seat.
2. Switch off all electric consumers.
3. Lock the seat console into place.
4. Press the service brake.
5. Apply the parking brake.
6. Insert the starting key.
7. Turn the starting key to position
1 .
8. All indicator lights illuminate for two seconds.
9. Turn the starting key in position
1 until indicator light A (pre-heating)
goes out.
➥
Indicator light B (alternator charge) illuminates.
➥
Indicator light C (engine oil pressure) illuminates.
10.Turn and hold the starting key in position 2 until the engine starts.
➥
Release the starting key.
➥
All indicator lights go out.
If the engine does not start after 30 seconds:
Interrupt the start procedure and repeat it after two minutes.
If the engine still does not start after a few tries, contact a Wacker Neuson
service center.
Warm-up phase
After starting the engine, let it warm up at slightly increased idling speed
until it reaches its operating temperature.
Check for unusual noise, exhaust color, leaks, malfunctions or damage.
In case of malfunctions, damage, or leaks:
Secure the vehicle, park it and find out the cause for the damage and
have it repaired.
Fig. 92
0
1
2
Fig. 93
A C B