Wacker Neuson 803 dual power, Руководство оператора

Страница: 61 / 228

OM 803 us – Edition 3.7 * 803b320.fm
3-7
Operation
3.4 Putting into operation
Information!
Machine operation is only allowed when seated on the seat.
Safety instructions
• Always use the climbing aids when climbing aboard the machine – see chapter 3.8
Access to the control stand on page 3-28.
• Never use the controls, lines or cables as handles.
• Never get on a moving machine. Never jump off the machine.
• Observe the lift capacity table (see chapter “Technical data – lift capacity table”).
Putting into operation for the first time
Important information
• The machine may only be put into operation by authorized personnel
– see chapter 1.8 Regulations on page 1-7
– see chapter Selection and qualification of personnel, basic responsibilities on
page 2-5!
• The personnel must have read and understood this Operator’s Manual before putting
the machine into operation.
• The machine may only be used in technically perfect condition in accordance with its
designated use and the instructions set forth in the Operator’s Manual, and only by
safety-conscious persons who are fully aware of the risks involved in operating the
machine.
• Go through the “Start-up” checklist in the following chapter
Running-in period
Handle the machine carefully during its first 50 operating hours.
Observe the following recommendations during the running-in period to ensure full output
and a long service life of the machine.
• Do not change engine speed abruptly!
• Avoid using the machine under heavy loads and/or at high speeds.
• Avoid abrupt acceleration, braking and changing traveling direction.
• Do not run the engine at high speed for extended periods.
• Strictly observe the maintenance schedules in the appendix
– see chapter 5.16 Mainte-
nance plan (overview) on page 5-38.