Wachs FF 206, Руководство пользователя

Страница: 60 / 90

SDB-103 Small Diameter Beveler and FF 206 Flange Facer
56 Part No. 16-MAN-01, Rev. 4-1109 E.H. Wachs
4.
Insert and tighten an old tool bit in one slot of the cut-
ting head.
5.
Set the tool head down onto a bench vise and clamp
the tool bit in it to secure the machine body.
A Wachs assembly tool
(AT16-05) is available to
tighten the lock nut.
6.
Using a spanner wrench, tighten the lock nut while
rotating the main housing until you can feel a slight
drag. Back the lock nut off 1/4 turn.
7.
Remove machine from vise and remove the tool bit
from the cutting head.
8.
Replace the feed housing assembly and the 4 screws
holding it. Do not tighten the screws yet.
9.
Install the drive motor.
10.
Insert the mandrel into the machine and turn the feed
handle clockwise to engage the feed screw through the
feed nut housing. This will ensure proper feed nut
housing alignment with the mandrel.
11.
Tighten the 4 screws holding the feed housing assem-
bly.
P
ERIODIC
I
NSPECTION
C
HECKLIST
• The bevel gear sets and roller bearing should be
inspected every 100 hours of operation and lubricated as
needed.
• Check the main shaft bearings every 10 hours of opera-
tion. Remove the air motor, feed housing assembly, and
four screws. Refer to the exploded view drawings in
Chapter 8 for details.
• Every 10 hours of operation, inspect the front bushing
for signs of wear. Excessive chatter may indicate a worn
front bushing. If necessary, replace the bushing using
the procedure in Chapter 7.
• Inspect the mandrel threads for signs of wear every 10
hours of operation. Replace the mandrel if the mandrel
threads are damaged.
NOTE