WAC Lighting
www.waclighting.com
Phone (800) 526.2588 • Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone (516) 515.5000 • Fax (516) 515.5050
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone (800) 526.2588 • Fax (800) 526.2585
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAy, 2017
1
INSTALLATION INSTRUCTION
Lucio - LED Track Luminaires
WTK-6010*/WTK-6022*/WHK-6010*/WHK-6022*
WARNING
IMPORTANT: NEVER attempt any work without shutting off the electricity.
-
Read all instructions before installing.
-
System is intended for installation by a qualified electrician in accordance with the National Electrical Code and local
regulations.
-
Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or
switch ”OFF” the circuit breaker switch(es) that control the power to the fixture or room that you are working on.
-
Place the wall switch in the “OFF” position.
AVERTISSEMENT
IMPORTANT : Coupez l’électricité avant TOUTE manipulation.
-
Lisez toutes les instructions avant d’installer.
-
Système est destiné à être installé par un électricien qualifié en conformité avec le code national de l’électricité et les
règlements locaux.
-
Accédez au panneau central de disjoncteurs ou de fusibles de votre demeure et placez l’interrupteur principal en
position d’arrêt (« OFF »).
-
Placez l’interrupteur mural en position d’arrêt (« OFF »).
All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are
worn out or broken. Failure to follow this instruction could invalidate the UL listing of this fixture.
Overview:
Fixtures are designed for use on WAC Lighting’s W track systems.
LED TRACK LUMINAIRE
TRACK SYSTEM
WTK-6010*/ WTK-6022*
WTK 120V W Track
WHK-6010*/ WHK-6022*
WHK 277V W Track
Installing on Track
1. Make sure that the lock switch is in the unlock position and the circuit selection handle is in the off position. (See to Fig 1)
2. Align the alignment tab bump on the adapter with the groove/slot on the track (see Fig 2). Once aligned,
insert adapter into the track
W Track
Switch handle
(power off position)
Lock switch
(unlock position)
Adapter
Groove
Alignment tab
Fig 2
Fig 1
