2 - 14
INSTALLATION
FEBRUARY 2014
32DSSST04.D.4
S-SERIES PUBLIC USE SERVICE MANUAL
3.
PLATFORM PRESSURE SWITCH CHECK AND ADJUSTMENT
Correct adjustment of this pressure switch will prevent platform from folding into vehicle when there is a load of 50
lbs, or more, on the platform.
a. Refer
to
Figure 2-20
. Deploy and lower platform to ground.
RSM0003600
A P P L Y 5 0 LB . L O A D
N O T E : H A N D R A IL S N O T S H O W N
F O R C L A R IT Y .
KNUCKLE L IN K
FIGURE 2-20: PRESSURE SWITCH TEST AT FLOOR LEVEL
NOTE:
Weight must be 50 lbs. and placed 6 inches from rear edge of platform mesh as shown in
Figure 2-21
.
FIGURE 2-21: 50 LB. WEIGHT PLACEMENT ON PLATFORM
b. Place a 6” x 6” x 12”, 50 lb. load on the rear, center portion of platform then raise platform to floor level by
pressing and holding the STOW switch.
c. Refer
to
Figure 2-22
. If an alternate weight is to be used, the center of the weight must be 6 inches from
the rear edge of the platform mesh.
