WABCO TAILGUARD, Описание системы

Страница: 35 / 64

35
Start-up
8 .3 Parameter setting in TEBS E diagnostic software
WABCO offers the electronic control unit "Electronic Extension Module" as a
universal system that must be adjusted to the respective vehicle type by means
of parameters. TailGUARD will not function without these settings.
The parameters are configured using the TEBS E diagnostic software.
For vehicle series production, prepared parameter sets can be copied into
Electronic Extension Module.
Please note that new ECUs respectively require the most recent version of the
TEBS E diagnostic software.
Start-up of vehicles with prepared interface for TailGUARD:
The current Diagnostic Software TEBS E (as of version V5.10) is required.
The Electronic Extension Module requires a new firmware, which you can
obtain via http://wabco.info/i/49 . Use the
System
=>
ECU-Update menu
to
install this firmware.
User guidance in the TEBS E diagnostic software is based on the required
configuration steps. Operation of the software is self-explanatory and
comprehensive assistance is also provided within the software.
Ordering the TEBS E diagnostic software
– Open the myWABCO website:
http://www.wabco.info/i/1367
Help on logging in can be obtained by pressing the
Step-by-step
instructions
button. After you have successfully logged in, you can
order the TEBS E diagnostic software via myWABCO.
Please contact your WABCO partner if you have any questions.
Vehicles with a prepared interface for TailGUARD:
For systems with a prepared interface for TailGUARD in the vehicle, a
parameter file (ECU file) is available that is preconfigured to the extent that
only the sensor configuration needs to be adjusted. The file is stored in the
default read directory of the Diagnostic Software when it is installed; the file
name is "TailGUARD_Truck_and_Bus_ESA-R.ECU".
Offline Parameter setting
Defining a parameter set is performed directly on the vehicle because the
configured function can be tested straight away. However, a parameter set can
also be prepared without a vehicle and stored on the PC for later use.
8 .4 Functional test
Setting the parameters is usually followed by the functional test. You can
only perform the function test (EOL test) if you have taken part in the TEBS E
training course.
All tests are carried out via the
Start initial start-up menu. The following test
steps are only carried out if "autonomous braking" was defined in the parameter
setting.