8
P05 - Engine power
P06 - Wheel diameter
Unit: inches, accuracy to 0.1
P07
-
Number
of
magnets
for
speed
measurement
1
– 100
P08 - Speed limiter
P09 - Starting method
Just add speed and the scooter will start (Zero), it
is necessary to bounce your foot and then add
gas (Non)
P10 - Drive mode
0 - by bouncing (off)
1 - electric motor
2 - a combination of the above
P11 - Assistance sensitivity
1
– 24
P12 - Starting speed
0 (lower)
– 5 (higher)
P13 - Magnetic ring adjustment
5, 8, 12
P14 - Current
1
– 20 A (for service only)
P15 - Motor speed transmission limitation
100
P16 - Cruise control
1
– on, 0 – off
P17 - Synchronization of lights and backlight
after start-up
1 - lights and backlight do not start after start-up
2 - lights and backlight start after start-up
P18 - Start password setting
1
– yes, 2 – no
P99 - Factory reset
Hold down the MODE button for 5 - 6 seconds for
factory settings
ODO: ODO
Hold down the MODE button for 5 - 6 seconds to
reset the total distance traveled
Hold down the power button
for 3 seconds to start or stop. Once started, you can use the button
to switch between the displayed ODO, TRIP, V, A, E and TM functions.
Hold down
and
to enter the settings. Press
to switch between parameters, press
to enter parameter settings. Use the
and
buttons to adjust the parameters. Hold
down the button
to exit the parameter.
Hold down the button
to turn on the light.
REMOTE CONTROLLER
Alarm lock
- triggers an alarm when the scooter moves
Lock without alarm
- locks the display + press to turn off an already triggered
alarm
Horn
- A short warning sound signal
