7
Total distance:
Speed mode:
Lights:
USE
Turn the key to start / stop the scooter. Use the
button to switch speed modes (1
– 2 – 3 – 2 – 1).
When turned on, the display shows the current distance traveled (TRIP). Press the
button, to
changed display information in order: currently traveled distance (TRIP), total distance traveled (ODO),
battery voltage (VOL).
Hold the
button to turn on / off the lights.
If the battery is low, the last battery cell will flash on the display. At this point, it is possible to travel a
short distance, but we recommend recharging the battery as soon as possible.
SETTINGS
To enter settings, hold
and
buttons .
Press the
button to change paremeters, press the
button change the value.
To exit settings, hold
and
buttons. Then wait 30 seconds.
PARAMETERS
P1 Backlight
Range: 0
– 3
Default value: 1
P2 Voltage
Settings: 36V, 48V, 60V
For service department only
Default value: 36V
P3 Power save mode
Unit: minute
0
– turn off
Default value: 0
P4 Method of speed measurement
1
– phase voltage
2
– engine speed measurement
For service department only
Default value: 2
P5 Number of speed measuring magnets
Number of magnets per revolution
For service department only
Содержание Billar II
Страница 1: ...USER MANUAL EN IN 23927 E scooter W TEC Billar II 500W 12...
Страница 9: ...9...