W.E.S.T. Elektronik POS-123-P-PFN, Техническая документация инструкция

Страница: 48 / 53

Page 48 of 53 POS-123-P-PFN 31.03.2021
7.7.2 Parameter List
Parameter Table
Nr. Index Parameter Description
1 0x2001 SENS Error monitoring: 1 = ON, 2 = OFF, 3 = AUTO
2 0x2002 EOUT Output signal in the case of missing activation
3 0x2003 HAND:A Control value in manual mode, direction A
4 0x2004 HAND:B Control value in manual mode, direction B
5 0x2005 POSWIN:S Window for status message Target position
6 0x2006 POSWIN:D Window for status message contouring error
7 0x2007 SYS_RANGE Working Stroke
8 0x2008 SIGNAL:X Type of the input signal: 1 = OFF, 2 = U0-10 , 3 = I4-20, 4 = U10-0 , 5 = I20-4
9 0x2009 N_RANGE:X Nominal Sensor Length [mm]
10 0x200A OFFSET:X Sensor Offset [µm]
11 0x2011 VRAMP Speed demand ramp time
12 0x2012 VMODE Positioning Method, 1 = SDD, 2 = NC
13 0x2013 VMAX Maximum speed of the axis
14 0x2014 ACCEL Acceleration for the profile generator (NC)
15 0x2021 A:A Acceleration direction A (SDD)
16 0x2022 A:B Acceleration direction B (SDD)
17 0x2023 D:A Deceleration direction A
18 0x2024 D:B Deceleration direction B
19 0x2025 D:S Stop distance
20 0x2026 V0:A Loop gain direction A
21 0x2027 V0:B Loop gain direction B
22 0x2028 V0:RES Resolution of the loop gain, 1 = 1, 2 = 1/100
23 0x2031 PT1 PT1 Filter for the position controller
24 0x2032 CTRL Deceleration behaviour, 1 = LIN; 2 = SQRT1, 3 = SQRT2
25 0x2041 MIN:A Deadband compensation A
26 0x2042 MIN:B Deadband compensation B
27 0x2043 MAX:A Maximum control direction A
28 0x2044 MAX:B Maximum control direction B
29 0x2045 TRIGGER Threshold for the Deadband compensation
30 0x2046 OFFSET Zero-point correction for the output signal
31 0x2047 SIGNAL:U Polarity of the output signal 1 = +, 2 = -
32 0x2051 CURRENT Rated current of the magnet
33 0x2052 DFREQ Dither frequency
34 0x2053 DAMPL Dither amplitude
35 0x2054 PWM PWM frequency, preset in steps according to table in 5.6.4,. 1 = 60 Hz, ..,, 20 = 2941 Hz
36 0x2055 IMS Maximum current limit
37 0x2100 SAVE Saving the data set
38 0x2200 PW Password for parameterisation