W.E.S.T. Elektronik POS-123-P-PFN, Техническая документация инструкция

Страница: 34 / 53

Page 34 of 53 POS-123-P-PFN 31.03.2021
5.7.2 AIN (Analogue input scaling)
Command Parameters Unit Group
AIN:X
A
B
C
X
a= -
10000… 10000
b= - 10000… 10000
c= - 10000… 10000
x= V|C
-
-
0.01 %
-
IO_CONF (MATH)
This command offers an individual scalable input. The following linear equation is used for the scaling.
) ( c Input
b
a
Output
− =
The
“C” value
is the offset (e.g. to compensate the 4 mA in case of a 4… 20 mA input signal).
The variables A and B are defining the gain factor with which the signal range is scaled up to 100 % (e.g. 1.25
if using 4… 20mA input signal, defined in default current settings by A = 1250 and B = 1000). The internal
shunt for the current measuring is activated with switching the
X
value.
The gain factor is calculated by setting the usable range (
A
) in relation to the real used range (
B
) of the input
signal. Usable are 0… 20mA, means (
A
) has the value 20
. Really used are 4… 20mA, means (
B
) has a value
of 16 (20-
4). Not used are 0… 4mA. In a range of 20mA this is an offset of 20%, means a value of
2000 for
( C ). Last but not least ( X ) has to be set to C choosing current signal.
In this case AIN command would look like this:
AIN:I 20 16 2000 C or AIN:I 1250 1000 2000 C (see below)
Typical settings:
Command Input Description
AIN:X 1000 1000 0 V 0… 10 V Range: 0… 100 %
AIN:X 10 8 1000 V OR
AIN:X 1000 800 1000 V 1… 9 V
Range: 0… 100 %; 1 V = 1000 used for the offset and
gained by 10 / 8 (10 V divided by 8 V (9 V -1 V))
AIN:X 10 4 500 V OR
AIN:X 1000 400 500 V 0,5… 4,5 V Range: 0… 100 %; 0,5 V = 500 used for the offset and
gained by 10 / 4 (10 V divided by 4 V (4,5 V -0,5 V))
AIN:X 20 16 2000 C OR
AIN:X 2000 1600 2000 C OR
AIN:X 1250 1000 2000 C 4… 20mA
Range: 0… 100 %
The offset will be compensated on 20 % (4 mA) and the
signal (16 mA = 20 mA-4 mA) will be gained to 100 %
(20 mA).
Each of this parameterisation
for 4… 20 mA is setting the
range to 0… 100 %.