Vuzix M400C, Руководство разработчика

Страница: 10 / 61

2.3.2 Programmable Buttons
The hardware buttons on M400C use a default set of key codes that can be reprogrammed using
the Vuzix USB API Write Button Key Codes (Section 3.1.11) command. The setting is written to
non-volatile storage on M400C and will persist across power cycles until either reprogrammed
using Write Button Key Codes again or reset using Restore Defaults (Section 3.1.4).
Button Short Press Long Press
Front Right arrow ( 0x4F ) Up arrow ( 0x52 )
Middle Left arrow (
0x50
) Down arrow (
0x51
)
Back Enter (
0x28
) Escape (
0x29
)
Side F16 (
0x6B
) Sleep (
0xF2
)
Table 2.5: Default Key Codes
2.3.3 Non-Volatile Memory
An on-board non-volatile memory stores certain settings so that they will be remembered even
when M400C is unplugged from the host device. The settings stored in memory are:
• Display brightness
• Autorotation mode
• Left eye mode
• Button key codes
9 Revision 7 Vuzix Corporation