Vulcan-Hart VC4EC, Руководство по обслуживанию

Страница: 9 / 60

FULL SIZE ELECTRIC CONVECTION OVEN - REMOVAL AND REPLACEMENT OF PARTS
F25105 (Rev. A, October 2007) Page 9 of 60
5. Remove probe by pushing it through the oven
wall and into the control panel area.
NOTE: The hole in the oven cavity wall does not line
up straight with the oven cavity outer shell, therefore
the probe must be removed at an angle.
6. Reverse the procedure to install the
replacement probe.
7. Adjust the temperature control as outlined under
SOLID STATE TEMPERATURE CONTROL
CALIBRATION in SERVICE PROCEDURES
AND ADJUSTMENTS.
HEATING ELEMENTS
NOTE: Starting with production in October, 2001, the
top cavity panel will have 3/4" square holes for easier
element removal. Ovens manufactured prior to this
date have 1/2" round holes that sometimes make it
difficult to remove elements thru the cavity. A serial
number cut off will not be available. Follow the
procedures for element removal as outlined below.
Front Access
1. Remove the oven racks and rack supports.
2. Remove the "top" door seal from the oven.
3. Determine if the heating element to replace is
on the left or right side in the oven cavity. The
element locations from front to back are: Right
side - R1, R2 & R3; Left side - R4, R5 & R6.
A. Measure the current draw of the heating
elements as outlined under HEATING
ELEMENT TEST in SERVICE
PROCEDURES AND ADJUSTMENTS.
4. From inside the oven cavity, remove the
perforated panel from the same side of the
element being replaced.
A. If removing the right side panel, also
remove the probe guard or mounting clips.
B. Run the probe wire thru the panel opening
before lifting panel out.
5. From the element being replaced, remove the
hold down clamps, the mounting bracket screws
at the top, then remove the element.